Email this Site  
GSG-5 & GSG-5P Cocking handle buffer Installation Instructions
For Gen 1 & Gen II

Unscrew the fake can and remove,
Unscrew hand guard screw and remove Hand guard (Picture 1)

Make sure you have the cocking handle in forward position.
You will see three screws in the front receiver, take the top one out and loosen the bottom two. The front sight, cocking handle housing assembly will slide off the barrel (Picture 2 and 3)

move the cocking handle back until you see the screw that holds it in the cocking tube, remove screw and remove cocking handle from cocking tube. (Picture 4 and 5)

Install cocking handle buffer (picture 6) and reverse process to put every thing back together.
After you have done it once it only takes a couple of minutes.



JP Grips & Machine

23 7th Ave NE, Pelican Rapids, MN 56572